Strip Rolling Mill - Data Form

To help us to engineer and quote the most suitable Rolling Mill(s) which meets your specific requirements, please answer the following questions as thoroughly as possible.

Customer Information
Name: 30space.gif (59 bytes)
Company Name:    
Address:
City:
State:
Postal Code:
Contact Person:
Telephone Number:
Fax Number:
E-mail:

1. Inlet Material
a. Specify material to be rolled (e.g. material specification, chemical composition etc):

b. Was the previous operation HOT or COLD rolling:   Hot Cold

c. Is the material to be rolled  HOT and/or COLD:  Hot Cold

d. What is the maximum tensile
strength of the ingoing material:
e. Maximum width of strip:
f. Maximum weight of piece:
 
g. Maximum in-going thickness:
h. If the material is rolled in short lengths, specify length of
Running-in and Running -out tables required:
Length of Running-in table:
Length of Running-out table:

i. If the material to be rolled is in coils, specify coil size:

 
Coil size: I.D. x
O.D. x Wide:
 

2. Finished Material

a. Maximum finished thickness:
    Allowable tolerance:
b. Minimum finished thickness:
    Allowable tolerance: 
c. Minimum finished width
    (if less than 1e):
d. If the finished material is
    required in coils, specify
    I.D. of coil:
e. State type of lubricant used
    (e.g. water soluble,
    mineral oil, etc.):
   

f. Does the finished material have to conform with any recognized national standards:
Yes:    No:

If  Yes, please specify):

3. Production Requirements

a. Number of working hours per year:
b. Total annual output required:

c: If possible, specify individual outputs of each thickness and width. (Note: If this information is not given, we will assume that the total output is of a mean thickness determined by 2a and 2b and of a mean width determined by 1e and 2c.

SECTION OUTPUT

4. Mill Requirements

a. Is a reversing or non-reversing mill required:
b. Is hand or power screwdown required:

c. Is Automatic Gage Control (AGC) required:  Yes:    No:

d. Is thickness gage equipment required:  Yes:    No:

If Yes, is there a preference for any particular type or make of gage: 

e. Is a roll changing rig required required:   Yes:    No:

f. Specify shop air supply pressure: 

g. Is any or all of the instrumentation used to measure the following parameters required?:

i.   Roll separating force:
ii.  Rolling torque:
iii. Back tension:
iv. Forward tension:

If so, specify if data collection and reporting system (SPC) is required: 

5. Electrical Supply

AC voltage:
No. of phases:
Frequency (Hz):

a. Altitude of plant and maximum ambient temperature:

6. Please list any relevant information particular to your requirements:

 
 
 FENN MANUFACTURING   |  300 FENN ROAD  |  NEWINGTON, CT  06111   |   860.594.4300