1. Inlet Material
a. Specify material to be rolled (e.g. material specification, chemical composition etc):

b. Specify mat’l condition (e.g. hot rolled, cold drawn, etc.):

c. Specify coating (if any):

If possible, please send detail drawing of spool.

2. Finished Material

a. Largest section (specify tolerances):

b. Smallest section (specify tolerances):

c. Maximum finish width/finish thickness ratio (i.e., 2:1, 3:1, etc.):

d. Edge requirements:

Natural (as rolled, no edging):
Square (specify corner radius):
Round (radius = ½ thickness):

e. What is maximum coil weight on take-up reels (lbs. or Kgs):

f. If collapsible drum is required, specify dimensions:

g. If finishing on spools, give dimensions or enclose drawing:

3. Production Requirements

a. Number of working hours per year:

b. Total annual output of all sections:

c. If possible, specify individual output of each section:

4. Mill Requirements

a. Is hand or power screwdown required:

Manual hand wheel
Electro-mechanical
Hydraulic cylinder
No preference

b. Is width and/or thickness gage equipment required:  Yes No

 
If Yes, is there a preference for any particular type or make of gage:

c. Do you want a quotation on carbide shell rolls:    Yes No

d. State type of rolling lubricant used (e.g. water soluble, mineral oil, etc.):

5. Utilities

a. Specify shop air supply pressure:

b. Power supply:

A.C. voltage: No. of phases: Frequency (Hz):

c. Altitude of plant and maximum ambient temperature:

6. Please list any relevant information particular to your requirements: